+90 533 085 67 33 info@sdfticaret.com Monday - Friday: 09:00 - 18:00
TR EN
Contact Customer Login

MIDGOLD FUMED GRADE BASE SILICONE RUBBER

MIDGOLD FUMED GRADE BASE SILICONE RUBBER — representative product illustration SILICONE RUBBER

Product Code: SDF-SIL-066

MIDGOLD FUMED GRADE BASE SILICONE RUBBER: Transparent fumed-grade HTV silicone-rubber base in 30–80 Shore A grades for extrusion and moulding.

Why does it matter?

In HTV silicone selection, hardness grade, extrusion/moulding method, catalyst and post-cure conditions jointly determine final performance.

Application and selection checklist

  • Define the required Shore A grade.
  • Verify catalyst and dosage with current TDS/SDS.
  • Record cure and, where needed, post-cure cycle.
  • Confirm critical compliance such as food contact with batch documentation.

For product matching, samples and quotation, see the technical product and documentation request.

Technical Details

Technical values are transcribed from the linked manufacturer document or, where equipment has no TDS, from verifiable information in the product name. Use the current TDS/SDS, batch certificate and an actual production trial together for design and process decisions.

Technical Specifications

Series GFD20x1P
Appearance Transparent
Hardness grades Shore A 31, 40, 50, 60, 70, 80
Density range 1.08–1.20 g/cm³
Tensile strength ≥6.5–8.0 MPa depending on grade
Elongation ≥200–750% depending on grade
TDS test cure 2% C15, 170°C × 10 minutes
Recommended service condition Below 200°C

Areas of Use

Profile and tube extrusion

Cables and hoses

Gaskets and seals

Moulded silicone parts

Advantages

Good processing behaviour

High strength and elongation

RoHS and REACH conformity statement

FDA and LFGB grade statement

Broad hardness range

S.S.S

Frequently Asked Questions

Which application suits MIDGOLD FUMED GRADE BASE SILICONE RUBBER?
Transparent fumed-grade HTV silicone-rubber base in 30–80 Shore A grades for extrusion and moulding. Final suitability must be validated for substrate, process conditions and a small-scale trial.
What information should be supplied before ordering?
Provide substrate, production method, target temperature, part size, annual consumption and existing equipment details.
Are TDS values guaranteed design values?
No. Unless explicitly stated otherwise, they are typical values under manufacturer conditions; current TDS/SDS and batch documents take precedence.
Similar Products

Products You May Like

All Products